noobtours.blogg.se

Setting up diy hi hat addictive drums 2
Setting up diy hi hat addictive drums 2













setting up diy hi hat addictive drums 2

You may find that angling your toms will be more comfortable than setting them up completely flat, although this can vary depending on the height of your drum throne. If it’s uncomfortable to hit your floor tom, try angling the tom slightly toward you. For drum arrangements with more than one mounted tom, you can place your toms so they are a few inches apart and sit at equal angles. The arrangement of your toms can be changed to make it easier to play. Your floor toms should be set so it is roughly the same height as your snare drum, while your mounted tom (or toms) should be set up at a slight angle towards you. Most drum sets have two types of toms: floor toms and mounted toms. Most drummers set up their snares flat, although traditional players sometimes set their drums so that it slightly tilts down and away. Set up your drum so your snare throw-off, the lever that engages the snare, is on the left-hand side of your drum. The height of your snare drum should be set a few inches above your leg and set so you can easily hit the drum with either of your hands without hitting the rim of your drum. Most pedals have a knob or screw that you can turn to control the tension, but this may be different depending on your model.Īs you arrange your drum kit, you will need to adjust the height of your snare drum. If the tension is too loose, you’ll need to adjust the tension to be tighter so the drum head springs back. If the pedal stays on the drum head and does not bounce back, then the tension is too loose. If stepping on the pedal is too hard or makes your legs tired, then you’ll need to adjust the action or tension of the bass pedal to make it less tight. As you step on the pedal, the beater should strike the bass drum head in the middle of your drum and then bounce back. You can find the bass drum pedal attached to the hoop of your bass drum. When setting up your drum set for the first time, pay special attention to the bass pedal.

setting up diy hi hat addictive drums 2

Check the tips of the legs on your bass drum to make sure they dig into the floor and prevent your drum from sliding around. These are used to anchor your bass drum to the floor so it doesn’t move around as you play.įor this reason, it’s important to adjust the legs so they are equal on both sides, since unequal legs will cause your drum set to wobble during play. Note that your bass drum has adjustable legs. Place your bass or kick drum so that it’s at the center of your drum kit.















Setting up diy hi hat addictive drums 2